Yahoo Message Number: 76547 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/76547)
Power to the water pump is not staying at 12v, goes to 3v at some point after turning on manually or otherwise. Have tried replacing pump. We have 3 switches that will not turn on pump. Works intermittantly for periods of time, but then stops. Does anyone know location of the relay that the switches go to or have a wiring diagram for a similar CC model? Thanks much! Tina
Yahoo Message Number: 76551 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/76551)
Before you do anything else, I recommend you find/check/clean the ground connection for the pump.
Jay
05 Inspire
Yahoo Message Number: 76582 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/76582)
If you follow the wiring from the pump you will find an Intelitec controller. You may need to replace the controller with a 15 amp unit to supply adequate power to the newer higher volume pumps.
You also need to verify all the conections (both ends) are clean dry and tight.
Bob Wexler
SOB
Yahoo Message Number: 76587 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/76587)
Thanks for the advice Jay, we will check it when we are at the RV in a couple of weeks, sounds like a very logical possibility.
Tina