Yahoo Message Number: 78792 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/78792)
I am getting a Warning W16 on the RS3000 panel. The warning states 'Line 2 AC voltage too low, Inv/Chg may go to invert'. This warning message only lasts less than one second, so you'd never notice it if you were not standing there watching it. I'm plugged in a 4 wire 240/120 VAC 50 amp receptacle in my garage. Just to be sure, I started the generator and it continued to show the same warning every few minutes. You can watch the line 2 voltage readout go down to 87 volts for less than a second and then back to 123. It did seem to happen less frequently with the generator running and all 3 a/c's on. I am new to this coach so any ideas to point me in the right direct would be awesome!
Gary Ghio
06 Intrigue 12068
Yahoo Message Number: 78793 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/78793)
I have also experienced the same fault warning for a one to two seconds which I have ignored since my independent voltmeters show the proper levels also the fault memory on the RS 3000 does not record the fault I think this is a bug in the software which I have updated twice Bob 06 intrigue 12047