Yahoo Message Number: 84266 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/84266)
I have a copper/brass radiator suspended at each side with vib. isolators. The bottom of the radiator has brass angles welded to the radiator on each side. The angles are bolted to a horizontal threaded rod connected to the frame.
The brass angles have broken at the radiator. Is there any way to fix this with out removing the radiator? Is the whole radiator/c.a.c./tran. cooler etc. assembly supported by the the radiator suspension vib. isolators?
Gordon
2005 INSPIRE 36ft. 51481
Yahoo Message Number: 84269 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/84269)
Gordon,
see attached a couple of jpgs that I created to show how I did the angle support for my rig.
Also some real photos on my rig..
Mike Laosa may photo his install also and send on to me, if I get I will send them on.
Call with any questions
Jerry
Jerry Moore
10 Scenic Way
Middletown, NJ 07748
jmoorepb@...
732-233-4797
2005 Inspire 40'
#51241
2012 Jeep GC
FMCA F29186
blog http://autocadddesignservice.com/wordpress/ (http://autocadddesignservice.com/wordpress/)
Jerry Moore
Auto Cadd Design Service LLC
10 Scenic Way
Middletown, NJ 07748
phone 732-671-6080
mobile 732-233-4797
fax 732-671-5860
email jmoorepb@...
email jmoorepb@...
email jmoorepb@...
www.autocadddesignservice.com (http://www.autocadddesignservice.com/)blog http://autocadddesignservice.com/wordpress/ (http://autocadddesignservice.com/wordpress/)