Yahoo Message Number: 85234 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85234)
I want to replace the Hyd filters on my coach. The filters (3) are Nelson elements no. 84220A but can't find the o-ring part number for the lid. I think i can get the filters from Cummins NW in Portland they may have the number don't know. The filter housing calls for Dexron II will Dexron III work? Floyd
2006 Inspire #51744
Yahoo Message Number: 85242 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85242)
yes dexron 111 will work and you can buy the filters at NAPA
Yahoo Message Number: 85311 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85311)
Cummings will have better prices than NAPA and you will be getting the OEM product.
Dan 2006 Allure 31348
Yahoo Message Number: 85312 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85312)
Floyd,
I paid #26.10 @ Cummings NW in Portland, OR. for 3 Nelson filters.
Jock Vargo
2005 Inspire
51428
Yahoo Message Number: 85324 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85324)
Yes i call Cummins and they have the filters but they don't have the o-ring number. A person would think they would have that number because that o-ring can only be used 1 time because of the high oil pressure in the system.
Floyd
2006 Inspire #51744
Yahoo Message Number: 85331 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85331)
Floyd
I have had my filters changed twice and I am sure they reused the o ring because I provided the filters and I did not get charged for anything other than the oil and labor.
Dan 2006 Allure 31348
Yahoo Message Number: 85337 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85337)
Dan
After spending 2 days reading different things on alot of different forums everyone said because of the high pressure in the system should have a new o-ring, so I found it I think. Will let you know if it is the right one, time will tell.
Floyd
2006 Inspire 51744
Yahoo Message Number: 85338 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85338)
Floyd,
Unless your system is different from mine there is no pressure at all inside the hydraulic reservoir. It's just a holding tank until the fluid is pulled out buy the suction side of the pump then after the fluid has done it's job it's returned back to the reservoir to be filtered and wait it's turn to be used again. Mine and I suspect yours also, has a open vent installed on the lid of the reservoir? This is to relieve any pressure that may build up.
No need to replace the O-ring unless it's becoming hard and/or brittle or has small cracks in it.
That's my story and I am sticking to it.
Barney
07 Inspire 52059
Yahoo Message Number: 85341 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85341)
Barney
You know, I like your story and I think you are right. I just went out and looked and it has a breather cap just like the hyd tank on a dump truck, Thanks.
Floyd
2006 Inspire 51744
Yahoo Message Number: 85344 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85344)
The tank or reservoir has little or no pressure. Usually the o ring can be reused.
Mikee
Yahoo Message Number: 85345 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85345)
When I changed my hydr fluid, the lid seal looked good, so I reused it (twice so far). As stated, there is no pressure at the tank.
Larry 03 Allure, 30856
Yahoo Message Number: 85348 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85348)
Floyd
If you can find the o ring it is probably cheap insurance and I am interested.
Dan 2006 Allure 31348
Yahoo Message Number: 85350 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/85350)
Dan
I will be going in on Friday to pick up more parts. Have not been out of the driveway and the cost keeps going up. Will post if it is the right part the Cat shop did not have the diameter or size of the o-ring so i told them just to order it, if wrong i'm out about $2.50 Floyd
2006 Inspire #51744