Yahoo Message Number: 95089 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/95089)
My high/low beam switch has failed. High beam works, low beam does not. At the cable harness plug, 12 voltage present in high beam wire, not in low beam. Bypassed the switch by jumping the plug 12 volt to the low beam wire and low beams come on. So the switch on the column seems to be bad (or loose wire at the switch) . Looks like the only way to get to the switch, is to pull the smart wheel.
Has anyone done this and if so, any help on how to do it and electronic/pdf manuals with information, would be very helpful.
Thanks in advance!
George, WB5LDN
08 Affinity 6877
Yahoo Message Number: 95095 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/95095)
You do not have to pull the smart wheel. I have changed this switch, got mine from Kevin Waite. I split the plastic collar and released them, a bit fiddly but can be done, Replacing the switch is easy after that.
Michael
2008 Allure 31683, in the UK!
Yahoo Message Number: 95129 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/95129)
George,
Take a look at the following site, it should help:
http://www.vipwheels.com/sites/default/files/uploads/pdfs/01460-I1V-_A.pdf (http://www.vipwheels.com/sites/default/files/uploads/pdfs/01460-I1V-_A.pdf)
Terry
08 Affinity #6837
Yahoo Message Number: 95136 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/95136)
Thanks Terry
What I need to do is get the turn signal/high-low switches off of the colume . Hope to try getting the boot off today, then remove the switch for testing and/or replacing.
I don't need to remove the wheel :-).
George, wb5ldn
08 Affinity 6877
George James, RN, BSN, MS
gjames@...
Sent from my HTC