Yahoo Message Number: 101755 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/101755)
The new part number I just received is 1090408. The one currently installed on the coach is 1090409.
Both are 12VDC 1.2A
They both have the same parameters: P0184204028E
It looks to me that to replace this thing, you have to take down a big long metal plate to get to bolts on the backside of the controller.
Yahoo Message Number: 101756 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/101756)
Well, I attached pics to the message. Not sure where they went.
Yahoo Message Number: 101758 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/101758)
I an not help you with your question, but your pictures were attached to the first message I got. The were down on the bottom of the page
Dave
07 Country Coach Allure 430 #31495
12 Jeep GC Toad
Mountains of So Cal and
Henderson, Nev
From: "randyflys@... [Country-Coach-Owners]" To: Country-Coach-Owners@yahoogroups.com Sent: Saturday, July 11, 2015 8:05 AM Subject: [Country-Coach-Owners] Re: Fan Controller - Will This Work? 2000 Allure
Well, I attached pics to the message. Not sure where they went.
Yahoo Message Number: 101760 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/101760)
Dutch, not sure this is your name, I just looked at your E-Mail Name. Here's the answer to your concern on the Fan Controller.
The entire assembly consisting of the Electronic Controller & Solenoid Valve Controller which was Purchased by Country Coach The Part # that's on the plate is #10900409, but when you purchase just the Electronic Controller which is 99% of the time the part that fails that Part # is #1090408.
The 4 parts you're looking at require either a star bit or square bit, just un-hooked the 6 pin and 2 pin connectors remove the 4 lengthy screws and save them, now put on your new #1090408 with those same screws there are NO NUTS. Clean up the connectors, put some new dialectic grease in the connections. There is no gasket or need to seal the new Electronic Controller to the Solenoid Valve Controller. Your new Electronic Controller is a Potted Seal.
Thanks, Mike 03 Allure 1st Ave.#30898