Yahoo Message Number: 104561 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/104561)
Intrigue 2001, original equipment of Pioneer sound system and back up camera source unknown. Anyone have the procedure for reprogramming the backup camera handy?? I used to know it but can't get into the proper mode of menu now and camera is black. Needs to be reprogrammed I believe. Help please\
Ron & Molly Bodeen, '01 Intrigue # 11262, San Diego CA. 619 994 0061
Yahoo Message Number: 104562 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/104562)
If it's a similar model, this should work:
Here's the directions for ours:
1. Turn your backup camera switch off.
2. Turn on the Pioneer system and watch the Dolphins jump.
3. Push the center of the round blue button on the right side of the stereo.
4. Note: (The blue round button has 5 positions, up-down-right-left and center)
5. Using the blue round button, push the bottom and scroll down to "SETUP"
6. Push the center of the blue round button to select "SETUP"
7. "VIDEO SETTING" should be highlighted, if not, using the blue button, scroll down to "VIDEO SETTING"
8. Push the center of the blue button to select "VIDEO SETTING"
9. Using the blue round button, push the left side and scroll over to "BACK UP CAMERA"
10. On that same screen, the bottom right corner should read 'BATTERY', if it does, skip to step 13.
11. If bottom area reads GND, then using the blue round button, scroll down and highlight that box.
12. Using the blue round button, push the left side and scroll to 'BATTERY'.
13. Next, push the little silver button labeled "WIDE" 3 TIMES, or until your radio comes back on. This button is to the immediate left of the blue round button.
14. Run on your "CAMERA" switch and your camera should be working. whew!!
Lonny & Diane Livingston
'04 Allure #31065
Yahoo Message Number: 104563 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/104563)
PS..
sometimes our camera stops working because the wires underneath the dash are loose. Poor design. There is a plug that works loose. If the reset procedure does't work, try "jiggling" the wires under the dash.
Lonny & Diane Livingston
'04 Allure #31065