Yahoo Message Number: 112031 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/112031)
My HWH compressor is not working. My control panel works and the coach levels by exhausting air until the bags are complete. I then start the engine and manually inflate the bags through the control panel.
I checked the breaker for the HWH compressor in the second panel, drivers side from the front. It appears I have a problem with the H19 ground wire. I have no idea where this ground wire goes to. Does some on have a clue?
Thanks
Mark
07 Inspire 51985
Buena Vista CO
Yahoo Message Number: 112034 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/112034)
Mark,
I don't know where the wire goes but I would install a temporary, known good ground to see if that solves the problem. If so I would either prove up the existing ground or run a new permanent ground of the appropriate size.
Good luck
George in Birmingham(in Santa Fe for the summer) '03 Magna 6298
Yahoo Message Number: 112035 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/112035)
George,
I was thinking the same thing, what size wire would you recommend? Can I run the ground straight to the battery ground?
Mark
Yahoo Message Number: 112040 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/112040)
Mark,
I assume you can see the wires on the compressor. I would use the same size as originally installed. If you have your schematics the wire size is identified on that drawing.
George in Birmingham
'03 Magna 6298