Hi There; I was trying to change a light bulb and some how, the two leads bent and shorted the circuit. (I think). Lights went on and then, boom, off, and I pulled the bulb out and the leads were bent and appeared to be touching. How do I reset the circuit. The other groups are fine, it just affected the one group. Any ideas on how to reset or chase down the issue.
Thanks in advance for your help.
Laura Lewis
2008 Magna
Need to find the intellitec controller for that circuit - there is a fuse on the controller for each output circuit - typically behind inspection/false panels - may be in upper cupboards in slide, under bed, in lower cabinet for kitchen etc. Possibly someone with same coach will respond.
Brian