Country Coach Owners Forum

Country Coach Restoration, Repair & Parts Forums => Country Coach Archive => Topic started by: Lee Casebeer_01 on August 09, 2004, 05:48:20 pm

Title: Slide-Out Won't Slide-Out
Post by: Lee Casebeer_01 on August 09, 2004, 05:48:20 pm
Yahoo Message Number: 10997 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/10997)
I was perfectly Level, but my Driver's Side Kitchen area slide would not slide out. The Forward Lower corner acts jammed. All other three corners attempt to move out. The hydraulic reservior is just below the end of the dip stick. I can not see anything that is stopping the one corner from moving out. Any suggestions as to what t I should look at?? Plan on removing the bottom inside facial board tonight, once it cool off, down below 90 degrees....
Thanks

Lee in Portland x '01, 36 ft. Intrigue, with Single Kitchen area Slide
Title: Re: Slide-Out Won't Slide-Out
Post by: Pcummings4 on August 09, 2004, 09:24:01 pm
Yahoo Message Number: 11007 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/11007)
Lee,

Call HWH for technical help, 800-321-3494. They are good people. I had a similar problem and it turned out to be one of the Sync Cylinder controls located above the Propane tank. You will need an Ohm meter to check it out. Getting the slide back in is a trick.
If the pump runs and you have a rear slide too, this may work. After closing the rear slide, hold the rocker switch down for 5 seconds and then go up front and press the rocker down. The slide may move in a inch or so due to pressure built up in the system. Continue until you can get the slide all the way in.

Good luck. HWH can ship you the part for about $38 dollars.

Paul, 01 Intrigue

In Country-Coach-Owners@yahoogroups.com (Country-Coach-Owners@yahoogroups.com), lcasebeer@c... wrote:
Quote
I was perfectly Level, but my Driver's Side Kitchen area slide
would not slide out. The Forward Lower corner acts jammed. All other three corners attempt to move out. The hydraulic reservior is just below the end of the dip stick. I can not see anything that is stopping the one corner from moving out. Any suggestions as to what t I should look at?? Plan on removing the bottom inside facial board tonight, once it cool off, down below 90 degrees....

Quote
Thanks

Lee in Portland x '01, 36 ft. Intrigue, with Single Kitchen area

Slide
Title: Slide-Out Won't Slide-Out
Post by: Lee Casebeer_01 on August 10, 2004, 12:56:03 am
Yahoo Message Number: 11014 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/11014)
Thanks Paul for the Advice.

Luckily the Slide is in Right Now. And I will not attempt to put it out until talking to HWH. And that looks like that is how we will use it going to FMCA National Rally in Redmond next week..We only have the one slide.
Lee in Portland, Oregon with 36 ft. '01 Intrigue. Single Slide