Yahoo Message Number: 16415 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/16415)
My A&E electric awning will not stay out with the wind sensor switch in the on position. I've checked the settings on the dip switches in the control box (all off), the 15 amp fuze, there's no wind blowing, I've disconnected the wind sensor from the control box and tested it, but, when I put out the awning, it will stay out for about 30 seconds or so, then retract. With the wind sensor switch in the off position, it operates fine. I've contacted tech support at A&E (Dometic) and they say take it into a service center, which, I don't want to do at this point. My guess is the circuit board has gone bad. Has anyone else had this probelm and, if so, how was it solved. Terry 2004 Allure 31028