Print Page - Entry Handle "ends"

Title: Entry Handle "ends"
Post by: Joe Pehoushek on January 16, 2006, 05:14:08 pm

Yahoo Message Number: 20449 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/20449)

The chrome plated ends of my lighted door handle have corroded badly.
I would like to replace them.
1) Can anyone tell me if wiring runs THROUGH either of them?
2) Is there any trick to getting them off and replacing them?

Joe

2004 Allure 36 #31031

Title: Re: Entry Handle "ends"
Post by: Don S. on January 16, 2006, 05:21:39 pm

Yahoo Message Number: 20451 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/20451)

Joe, the handles have wires only in the top end. All you have to do is unscrew the handle and it will come off. The wires are long enough so you can work with the handle. Don't know if you can get just the ends, you might have to get a complete assembly. You can find the handle used by CC here www.itc-marine.com
Don

'02 Intrigue #11427

Quote from: Joe Pehoushek

Title: Re: Entry Handle "ends"
Post by: Truk4u on January 17, 2006, 08:41:43 am

Yahoo Message Number: 20458 (http://groups.yahoo.com/neo/groups/Country-Coach-Owners/conversations/messages/20458)

Joe,

I had the same problem, CC sent me a new handle at no charge and I was out of warranty. The plating on the handles are very poor. Just remove the screws, unplug the wire and switch it out.
Tom

04 Allure 30979

Country Coach Owners Forum

Country Coach Restoration, Repair & Parts Forums => Country Coach Archive => Topic started by: Joe Pehoushek on January 16, 2006, 05:14:08 pm