Skip to main content ↑ ↓
Topic: Slide Seal Source (Read 569 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Slide Seal Source

Yahoo Message Number: 63370
I've been through the search function, but can't seem to find a source for the outer rubber seals for my galley slide. I want to replace the top, sides and bottom.
The Bedroom slide has rolled the bottom sweep rubber in two places and I assume the little metal fasteners are gone. I'm going to try to glue it back and need some advise on how to get a little space to work, sticking it in with my finger just isn't working.

Thanks,
Tom

01 Magna 5999

Re: Slide Seal Source

Reply #2 –
Yahoo Message Number: 63391
Tom, I'm sure Kevin can help you but I'll add a supplier that may help yoyou. Uni-Grip Corp. 419-294-2358, 9823 State Route 53 North, Upper Sandusky, OH www.uni-grip.com

Thanks, Mike 03 Allure 1st Ave. #30898

Re: Slide Seal Source

Reply #3 –
Yahoo Message Number: 63437
Thanks Mike, Kevin is helping me out. The bottom seal is the one with the little steel teeth and sounds like it's hard to find and expensive, but Kevin did find some for me. Jacking up the slide and replacing is going to be a challenge.

Tom

01 Magna 5999

Re: Slide Seal Source

Reply #4 –
Yahoo Message Number: 63443
Don't try to jack up the slide - raise the coach slightly, put solid support under the slide, and drop the side of the coach just a little. Same effect as raising the slide, but much easier.

Jim Brown

2002 Allure 30778
 

Re: Slide Seal Source

Reply #5 –
Yahoo Message Number: 63459
Jim,

I would have no problem jacking the entire slide, I have the equipment, but Kevin cautioned me against doing that and said to jack one side at a time. Must be a reason, but I didn't ask. Your idea of just dropping the air bags a little sounds reasonable and maybe Kevin will jump in here.

Tom

01 Magna 5999