Skip to main content ↑ ↓
Topic: slinde issue (Read 707 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

slinde issue

Yahoo Message Number: 88790
If it is not one thing it is another. I have a 2000 Intrigue with a kitchen slide. It works just fine, but when I put it in it slowly starts working its way out. Driving down the road it wants to start extending on its own. I put the come-along on it to keep it in, but it still goes out a few inches. What gives? Bad cylinder?

Al Colby

2000 Intrigue 10979

Re: slinde issue

Reply #1 –
Yahoo Message Number: 88792
Al you have a leaking valve. I would call HWH to determine which valve it is, I don't know which one off hand. Easy do it yourself replacement.

Don

'02 Intrigue #11427
'02 Intrigue #11427

Re: slinde issue

Reply #2 –
Yahoo Message Number: 88793
Did you check your fluid level? My first Allure did the same thing and it was one of the solenoids.
TWI 2004 Intrigue 11731

Re: slinde issue

Reply #3 –
Yahoo Message Number: 88795
If you check your fluid level, make sure you do it with the slide retracted.
I had the same problem with my galley slide on my Magna. It was one of the solenoid valves. I had HWH change it so I don't know how much work it is. I do know the pump, tank, and solenoid valves are in a compartment that is hard to get to.

pete

2000 40' Magna, CAT C10, #5892
Pete
 2000 40'  Magna #5892  CAT C-10
 

Re: slinde issue

Reply #4 –
Yahoo Message Number: 88812
I had a similar problem... my driver side living room slide was working it's way out a tiny bit (half inch) when driving. Tech showed me that there is a manual level for the brake on the motor and that had somehow been flipped over to the release position. He just flipped it back on and that ended the problem

Joseph Burkle

2008 Country Coach Inspire 360 Founders Edition 43' quad slide tag axle 425 HP C9 pusher http://www. Wind-seeker.com/