Skip to main content ↑ ↓
Topic: Exhaust tip for 1998 Allure (Read 1195 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Exhaust tip for 1998 Allure

Yahoo Message Number: 8293
Now I come to see the exhaust tip, the short (roughly 8" I guess) fat pipe that fits on the end of the muffler has rotted out and fallen off. Quality stuff! :>(

Anyone had to replace one of these and were you able to find one somewhere locally?

Dan & Ann

1998 Allure #30180

Re: Exhaust tip for 1998 Allure

Reply #1 –
Yahoo Message Number: 8304
hi at first I thought i could just replace the tip but shortly therafter the muffler rotted out also, fortunately the muffler from CC was relatively cheap, i went to NAPA and ordered a ehaust tip that gets the exhaust away from the body, of course CC had the muffler but no clamps hope this helps.
Rich Jacksic

!998 Intrigue 10487

Re: Exhaust tip for 1998 Allure

Reply #2 –
Yahoo Message Number: 8308
Dan & Ann,

I got a new piece from a local truck supply. I just cut it off to the length I wanted.

Steve

Intrigue #10673

Quote from: mainecoons0

Re: Exhaust tip for 1998 Allure

Reply #3 –
Yahoo Message Number: 8318
Steve, thanks for the tip. I was able to get one from a local truck supply as well and they cut two of them out of the same piece of pipe for a whopping $8. I'm going to have the other one chromed.

Dan

Quote from: rheavn

Dan & Ann,

I got a new piece from a local truck supply. I just cut it

off

Quote
to the length I wanted.

Steve

Intrigue #10673

[quote author=mainecoons0"

> Now I come to see the exhaust tip, the short (roughly 8" I

guess)

Re: Exhaust tip for 1998 Allure

Reply #4 –
Yahoo Message Number: 8320
Just a tip (get the pun) You can buy exaust extensions from JC Whitney online for a lot less than the chain stores. I was able to replace my rusty factory extension with an exact size stainless steel job.

Larry
Intrigure
10762

Puerto Penasco Mexico for a couple more weeks. OLA!

Re: Exhaust tip for 1998 Allure

Reply #5 –
Yahoo Message Number: 8330
I purchase a chromed Exhaust tip for my 2000 Allure. However, when I tried to install it, I could not remove the old Exhaust pipe extention. I was able to remove the clamp, but could not budge the tip. Even tried a chisel and hammer, but no luck.
Any tips or information on removing the old exhaust pipe tip would be appreciated.

Dick

2000 Allure 30592

Re: Exhaust tip for 1998 Allure

Reply #6 –
Yahoo Message Number: 8331
Dick, I had the same problem with a 200 Intrigue I owned. I finally took it to a muffler shop who heated it and it pulled right off. Trouble is, the torch is awfully close to the fiberglass, so make sure they're carefull. Interestingly, my 03 Allure came equiped with chrome (or stainless, I'm not sure which it is) tips for the engine, generator and Hurricane exhausts.

Walt Rothermel
03Allure30811

Re: Exhaust tip for 1998 Allure

Reply #7 –
Yahoo Message Number: 8340
Dick,

I had the same experience as you. Due to the fiberglas I didn't want to use heat. I used a 4" hand grinder & ground a slot through the extension from the inside out. Once I had about a 4" long slot it pulled right out.

Hope this helps.............
Steve

Intrigue #10673

Quote from: RBellaw
I purchase a chromed Exhaust tip for my 2000 Allure. However, when
I tried to install

Quote
it, I could not remove the old Exhaust pipe extention. I was able
to remove the

Quote
clamp, but could not budge the tip. Even tried a chisel and
hammer, but no luck.

Quote
Any tips or information on removing the old exhaust pipe tip would
be appreciated.

Re: Exhaust tip for 1998 Allure

Reply #8 –
Yahoo Message Number: 8341
OK...where did you get the tip? I would like to either replace the tip with a chrome or polished SS tip or even a sleeve. Exhaust is 5" in diameter and about 5-1/2" long. It is a bit close to the fiberglass cutout, so material thickness may be critical for a good fit.

Jim Hughes

2000 Allure #30511

Quote from: rheavn

Dick,

I had the same experience as you. Due to the fiberglas I didn't > want to use heat. I used a 4" hand grinder & ground a slot through > the extension from the inside out. Once I had about a 4" long slot > it pulled right out.

Hope this helps.............
Steve

Intrigue #10673

[quote author=RBellaw"

> I purchase a chromed Exhaust tip for my 2000 Allure. However,

when

Quote
I tried to install

> it, I could not remove the old Exhaust pipe extention. I was

able

Quote
to remove the

> clamp, but could not budge the tip. Even tried a chisel and > hammer, but no luck.

> Any tips or information on removing the old exhaust pipe tip

would

Re: Exhaust tip for 1998 Allure

Reply #9 –
Yahoo Message Number: 8342
JIm, I got mine from CC at an exhorbitant price--I believe about $40.

Walt Rothermel
03Allure30811

Re: Exhaust tip for 1998 Allure

Reply #10 –
Yahoo Message Number: 8343
Jim,

I got a chrome piece of tubing from a local truck supply. It was about $30. I was able to cut two pieces out of it.

Steve

Intrigue #10673

Quote from: Jim Hughes
OK...where did you get the tip? I would like to either replace the > tip with a chrome or polished SS tip or even a sleeve. Exhaust is

5"

Quote
in diameter and about 5-1/2" long. It is a bit close to the > fiberglass cutout, so material thickness may be critical for a good > fit.

Jim Hughes

2000 Allure #30511

Quote from: rheavn"[/quote
Quote
>]
> Dick,

> I had the same experience as you. Due to the fiberglas I

didn't

Quote
want to use heat. I used a 4" hand grinder & ground a slot

through

Quote
the extension from the inside out. Once I had about a 4" long

slot

Re: Exhaust tip for 1998 Allure

Reply #11 –
Yahoo Message Number: 8352
Quote from: Jim Hughes
OK...where did you get the tip? I would like to either replace the > tip with a chrome or polished SS tip or even a sleeve.
I got a piece of chrome exhaust pipe from a truck salvage yard. The had a piece from a wrecked truck. The piece was long enough for 2 pieces for my coach. They charged me $7.50 for the piece.

Dave G.

2000 Allure #30491
Millheim, PA

Re: Exhaust tip for 1998 Allure

Reply #12 –
Yahoo Message Number: 8438
went to a truck chrome shop and bought a 3' piece of chrome pipe and cut to fit most of the CC's are stainless very expensive

Brian

Intrigue 10030