Skip to main content ↑ ↓
Topic: water pump (Read 621 times) previous topic - next topic
0 Members and 2 Guests are viewing this topic.

water pump

Yahoo Message Number: 77014
Just arrived in Hudson. FL to have my fogged windows repaired. Wanted to use my pump for water instead of hooking up. Pump is running but not pumping water. I have about 5/8 of a tank of freash water unless the gauge is not working. Ideas?

Tom Coomes

2005 Inspire 51177

Re: water pump

Reply #1 –
Yahoo Message Number: 77015
make sure your valves are correct . Try loosing the suction line connection going to pump to make sure you have water going to pump. It should start dripping. Then tighten the suction and loosen the discharge to see if you big any pressure. You could have an air in the system.
Good luck.

Had my windows replaced a Suncoast also. Great people to deal with.

Buddy Inspire 06 51887

Re: water pump

Reply #2 –
Yahoo Message Number: 77016
Tom, try these:

Open all faucets to pump any air out of the system. (Don't forget the shower in the plumbing bay.)

Check the inlet screen to your pump.
Open the fresh water drain valve to make sure you have water in the tank.
Visually check the part of the tank located in the plumbing bay. You should be able to see the water level.

Hook up shore water and see if you get flow.

Jay

05 Inspire

Re: water pump

Reply #3 –
Yahoo Message Number: 77018
Try different valve settings in the water bay, If the valve that Tank fills isn't correct the pump wont pump.

Bill Krause Inspire

From: Jay Williams

To: Country-Coach-Owners@yahoogroups.com Sent: Tuesday, January 24, 2012 1:30 PM Subject: RE: [Country-Coach-Owners] water pump

Tom, try these:

Open all faucets to pump any air out of the system. (Don't forget the shower in the plumbing bay.)

Check the inlet screen to your pump.
Open the fresh water drain valve to make sure you have water in the tank.
Visually check the part of the tank located in the plumbing bay. You should be able to see the water level.

Hook up shore water and see if you get flow.

Jay

05 Inspire

Re: water pump

Reply #4 –
Yahoo Message Number: 77034
are you getting any air pressure out of the faucets? If yes, than you may be sucking air somewhere before the pump. If the pump has a prescreen than it may have cracked.

Dave aka Billy Byte (trusty hound) 2000 Allure #30443

water pump

Reply #5 –
Yahoo Message Number: 83598
Hello - We have an 07 Inspire. Looking for feedback on upgrading the water pump to increase the pressure at the showerhead. Any replies much appreciated. Logan.....#52000

Re: water pump

Reply #6 –
Yahoo Message Number: 83600
Have you removed the restrictor loked at the base (outlet) where the flex hose connects?

Jim 07 Allure #31570

Re: water pump

Reply #7 –
Yahoo Message Number: 83602
Quote from: JimS"

> Have you removed the restrictor loked at the base (outlet) where the flex hose connects? >

Jim 07 Allure #31570

Quote from: cloganll"

>

> Hello - We have an 07 Inspire. Looking for feedback on upgrading the water pump to increase the pressure at the showerhead. Any replies much appreciated. Logan.....#52000 > >
No, I haven't but I will.
 

Re: water pump

Reply #8 –
Yahoo Message Number: 83605
Are you wanting more pressure or more flow. We installed one of the variable output units that provides up to 5.7 gpm, I recall at something like 40 psi. I also removed the restrictors which provides a great shower whether from municipal or on board supply..
We very seldom operate from the on board water reservoir for more than a couple days so it is no problem but if boondocking this pump draws the reserve down pretty quickly. The Navy way is the best to minimize consumption.

Gerry Brown

2007 Allure 31447