Skip to main content ↑ ↓
Topic: Loose material in wheel wells (Read 1102 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Loose material in wheel wells

Yahoo Message Number: 5927
Some kind of insulating material is mounted above the wheels in the rear wheel wells in our '02 Allure. This material is coming loose in the center but still attached around the edges. With the airbags dumped for leveling the material nearly contacts the top tire surface.

Has any one else had this happen? Any ideas on how to securely reattach the material to the top of the wheel well? --

Tom Harsch '02 Allure #30791
 

Re: Loose material in wheel wells

Reply #1 –
Yahoo Message Number: 5929
Tom,

Same thing happened on mine shortly after purchase. I used the type nails with the round plastic caps that are used on roof felts. I think they were about an inch long. I used several of these and then applied some spray undercoating to conceal and protect. This insulating material was glued and stapled from the factory. I think the roof type nails will actually work better than the staples.

Rob

'02 Intrigue - #11480