Skip to main content ↑ ↓
Topic: Slide Wont Extend.....all the way (Read 549 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Slide Wont Extend.....all the way

Yahoo Message Number: 88035
2003 CC Magna, double slide, 505 HP Cat #6210
Been traveling around a bit and when we got to our spot in Santa Fe the bedroom slide wouldnt extend all the way. It goes more than half and stops. Took the bed off and nothing seems to be obstructing the slide on the inside and and the outside looks fine as well. I am wondering if I should use the HWH reset button in the control panel.

Advice welcomed please.

Luckily we can retract it and extend it, so we are not stuck.

Mark and Denise

Home is where the bus is...
 

Re: Slide Wont Extend.....all the way

Reply #1 –
Yahoo Message Number: 88043
When our BR slide did that it was because the hydraulic pump was not running. The slide went out part way because of the residual pressure left over from extending the LR slide. Check to see if the pump runs when you activate the switch. It not, hit the extend button on the LR slide (while it's extended) to pressurize the system while someone holds the extend button on the BR slide. It worked(s) for us. The fix was a new switch (for a while), but it still acts up occasionally. We have better luck operating the slides with the engine running.

Larry, 03 Allure 30856