Skip to main content ↑ ↓
Topic: CAT C-10 Wrist Pin Failure (Read 1286 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

CAT C-10 Wrist Pin Failure

Yahoo Message Number: 6595
Anyone out there with a Cat C-10 and experienced a wrist pin fatigue failure?

I own a 1999 CC Magna, 40 ft., 52K miles and had a wrist pin failure on no. 1 cylinder. I fished out two metal pieces from oil pan. One was 1 3/9 in. by 1/4 in. Second, smaller and it was 3/8 in by 1/4 in. Both pieces were crescent shaped and two different metal colors - copper like and cast iron. Appears problem maybe a latent defect in machining of the C-10 connecting rods. Machining caused very slight gap to exist between connecting rod and bearing surface.
Compression/combustion forces forced bearing to mate acrossed the slight gap between two surfaces and viola, you eventually have fatigue (like bending the paper clip until it breaks).

Let me hear from you.

Re: CAT C-10 Wrist Pin Failure

Reply #1 –
Yahoo Message Number: 6598
We have 38k on our C-10 and no failure.

Bill G. 2001 Magna #5998
 

Re: CAT C-10 Wrist Pin Failure

Reply #2 –
Yahoo Message Number: 6606
My '00 Magna with a C10 has no major problems in 60 thousand plus. I had a problem with the air-to-air radiator cracking and loose bolts on the C10 oil pump. jerry in NM, '00 Magns.