Ridewell leveling linkage

December 09, 2015, 08:52:16 pm

I recently had the small balljoint on my rear suspension break. The ball rusted in the socket and the shaft that is part of the ball, snapped. This immediately tipped the coach to the broken side and pulled the opposite side shock apart. I got it all fixed and pulled the rear linkage, that didn't break and it was free and tight in the socket. I tried to find the front suspension linkage, to check them, but no matter how much crawling around I did under there, I can't seem to find any. I would think there would have to be something to adjust the front ride height but then I am not an engineer. Any help would be appreciated.

Brett

08 Allure 470
31665

Re: Ridewell leveling linkage

Reply #1 – December 09, 2015, 10:49:12 pm

Yahoo Message Number: 104077

Brett, I have a 2000 Magna and there's only one in the front and two in the rear. the one in the front controls the front to rear and the two in the rear control the left to right. I'm not sure on your's, but I would assume it's the same as mine. The front is located in the center of the axle. If you have a owner's manual it's shown there. I hope that is of some help.

Chip

2000 CC Magna
5758

Country Coach Owners Forum Country Coach Motorcoach Forum