Skip to main content
Topic: Slide-Out Won't Slide-Out (Read 510 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Slide-Out Won't Slide-Out

Yahoo Message Number: 10997
I was perfectly Level, but my Driver's Side Kitchen area slide would not slide out. The Forward Lower corner acts jammed. All other three corners attempt to move out. The hydraulic reservior is just below the end of the dip stick. I can not see anything that is stopping the one corner from moving out. Any suggestions as to what t I should look at?? Plan on removing the bottom inside facial board tonight, once it cool off, down below 90 degrees....
Thanks

Lee in Portland x '01, 36 ft. Intrigue, with Single Kitchen area Slide

Re: Slide-Out Won't Slide-Out

Reply #1
Yahoo Message Number: 11007
Lee,

Call HWH for technical help, 800-321-3494. They are good people. I had a similar problem and it turned out to be one of the Sync Cylinder controls located above the Propane tank. You will need an Ohm meter to check it out. Getting the slide back in is a trick.
If the pump runs and you have a rear slide too, this may work. After closing the rear slide, hold the rocker switch down for 5 seconds and then go up front and press the rocker down. The slide may move in a inch or so due to pressure built up in the system. Continue until you can get the slide all the way in.

Good luck. HWH can ship you the part for about $38 dollars.

Paul, 01 Intrigue

In Country-Coach-Owners@yahoogroups.com, lcasebeer@c... wrote:
Quote
I was perfectly Level, but my Driver's Side Kitchen area slide
would not slide out. The Forward Lower corner acts jammed. All other three corners attempt to move out. The hydraulic reservior is just below the end of the dip stick. I can not see anything that is stopping the one corner from moving out. Any suggestions as to what t I should look at?? Plan on removing the bottom inside facial board tonight, once it cool off, down below 90 degrees....

Quote
Thanks

Lee in Portland x '01, 36 ft. Intrigue, with Single Kitchen area

Slide

 

Slide-Out Won't Slide-Out

Reply #2
Yahoo Message Number: 11014
Thanks Paul for the Advice.

Luckily the Slide is in Right Now. And I will not attempt to put it out until talking to HWH. And that looks like that is how we will use it going to FMCA National Rally in Redmond next week..We only have the one slide.
Lee in Portland, Oregon with 36 ft. '01 Intrigue. Single Slide