Skip to main content ↑ ↓
Topic: Atwood water heater - electric heating element replacement (Read 825 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Atwood water heater - electric heating element replacement

Yahoo Message Number: 16590
Has anyone ever tried to replace a rear-mounted Atwood water heater electric heating element?

Mine apparently burned out a couple days ago when I drained and flushed the HW tank without switching off the power. I did try the overtemp reset switch - no luck!

CC tech support says there may be enough space behind the tank to replace the element without pulling the entire tank out. Can anyone confirm this? I'd hate to get half way through the job and find out the tank has to come out.

The only tank connections I can see are the (flexible) heat exchanger hoses and power line. Are the oher tank connections (gas line, hot & cold water lines) flexible or rigid?

Is it a job that the CC techs would do at the Fargo pre-rally? --

Tom Harsch

2002 Allure #30791

Re: Atwood water heater - electric heating element replacement

Reply #1 –
Yahoo Message Number: 16591
It's not a simple procedure if your 2002 Allure's configuration hasn't changed in two years.
I tried to do the job without removing the unit and only messed up the 110V terminals which weren't very well protected IMO. I finally removed the unit (far enough w/o disconnecting the gas lines as I recall) and was able to fix everything without having to resort to painful contortions.

Be sure to do a soap test on the gas lines and seal up the unit with plenty of silicon after it's replaced and you should be back in business..about a two-three hr job.
Dick

2000 Allure #30519

Quote from: Tom & Maxine Harsch
 

Re: Atwood water heater - electric heating element replacement

Reply #2 –
Yahoo Message Number: 16628
An RV mobile service guy was working on my neighbor's coach today. He was able to replace the electric water heating element without disturbing the tank. It took him less than an hour and he only charged $40 (I already had the $22 part).
--

Tom Harsch

2002 Allure #30791

Quote from: Richard Stearns
> It's not a simple procedure if your 2002 Allure's configuration
hasn't changed in two years.

Quote
I tried to do the job without removing the unit and only messed up
the 110V terminals

Quote
which weren't very well protected IMO. I finally removed the unit
(far enough w/o

Quote
disconnecting the gas lines as I recall) and was able to fix
everything without having to

Quote
resort to painful contortions.
> Be sure to do a soap test on the gas lines and seal up the unit with
plenty of silicon after

Quote
it's replaced and you should be back in business..about a two-three

hr job.

Quote
Dick

2000 Allure #30519

Quote from: Tom & Maxine Harsch" [/quote
Quote
>]
> Has anyone ever tried to replace a rear-mounted Atwood water

heater

Quote
electric heating element? > >

> Mine apparently burned out a couple days ago when I drained and > > flushed the HW tank without switching off the power. I did try

the

Quote
overtemp reset switch - no luck! > >

> CC tech support says there may be enough space behind the tank to > > replace the element without pulling the entire tank out. Can

anyone

Quote
confirm this? I'd hate to get half way through the job and find

out

Quote
the tank has to come out.
>

> The only tank connections I can see are the (flexible) heat

exchanger

Quote
hoses and power line. Are the oher tank connections (gas line,

hot &