Skip to main content ↑ ↓
Topic: Oil Dip Stick Housing Failure (Read 1516 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Oil Dip Stick Housing Failure

Yahoo Message Number: 1820
It is apparent (recent failure on my Allure) that any contact of the dip stick housing with either the oil filter or the turbo housing will eventually lead to rupture of the housing and considerable loss of engine oil especially if the pak brake pressure reduction mod has not been performed (blowby pressure reduction).
It is important to check routing of the housing and tie wrap it away from any contact with another structure. The clamp support at the top of the housing may need to be modified to relocate the housing to help cure rubbing.
Fred Kovol

LAUNCH - Your Yahoo! Music Experience http://launch.yahoo.com

Re: Oil Dip Stick Housing Failure

Reply #1 –
Yahoo Message Number: 1826
What is the Pac Brake engine blowby mod?

Re: Oil Dip Stick Housing Failure

Reply #2 –
Yahoo Message Number: 1828
Hi Joey,

The back pressure is reduced from 20-24 psi to 12 psi by drilling holes in the pak brake butterfly valve which lets exhaust gasses through, this in turn reduces the oil pan pressure which reduces oil being expelled through the blow-by tube which is next to the oil filter. It also is to reduce the possibility of oil escaping through the front engine oil seal.
Fred Kovol

--- Joey joeyc@...> wrote:

Quote
What is the Pac Brake engine blowby mod? >

Re: Oil Dip Stick Housing Failure

Reply #3 –
Yahoo Message Number: 1959
Fred, did you catch it before you fried your engine?
Dick May
2002 Intrigue, #11438, towing a
2014 Jeep Gr Cherokee ecoDiesel

Re: Oil Dip Stick Housing Failure

Reply #4 –
Yahoo Message Number: 1965
Hi Dick,

Yes, I caught it during a check for leaks following a oil and filter change. I slide a plastic hose over the housing (Ace Hardware purchase) and clamped it at both ends. CC was concerned and their QC is to inspect on all production. Service is also aware - they replaced the housing and Doug Rutherford was emailed a picture.
Fred Kovol

--- MayMR maymr@...> wrote:

Quote
Fred, did you catch it before you fried your engine? >
 

Re: Oil Dip Stick Housing Failure

Reply #5 –
Yahoo Message Number: 23038
Mine failed when it was burned through by the Turbo housing heat. I think Lazy Days charged me one hour labor to change it out, can't remember what the cost of the newly designed one from country coach was but it has asbesto like material around the dip stick housing now. Hope that solves the problem.
This should be inspected periodically to be sure that the housing is not damaged and causing loss of oil

Ray

2000 Intrigue

Quote from: fred kovol\[br\
]