Galley slide

February 21, 2010, 11:00:18 am

I have a leak in my 2004 Inspire galley slide.I have done a little investigation and found the gap between the bottom to top of trim to wall varies 38". At bottom 12""-top 78",does anyone know of an adjustment that can be made to correct this, have checked Power Gear's website but unclear of fix. Bill 51166

Re: Galley slide

Reply #1 – February 22, 2010, 05:41:36 pm

Yahoo Message Number: 56727

Hi Bill

I also have a 2004 Inspire, and my Galley slide is as you describe, I also had a leak, but found it was not due to the slide being out of kilter a little, My leak was a void in the sealant on the front top angle piece, where it is sealed to the top of the slide, my leak was running inside the front wall through the hole in the missing sealant, I noticed the front wall bulge and the carpet was saturated, we are on the Oregon coast where there is a lot of rain,I resealed the angle with Sikalex (spelling) and no more leak,I managed to fix the wall bulge when I pushed on the wall board I felt the adhesive was still pliable, so I heated the wall with a blow dryer and kept pressure until it cooled and it worked its flat once again . I will get the slide adjusted when I get time. I would suggest you climb up and take a look at the front top edge of the slide under the slide awning, I used a mirror that's how I found the sealant void. Good luck

Jerry

2004 Inspire 51012

Country Coach Owners Forum Country Coach Motorcoach Forum