2007 Inspire 360 Coach # 52001 Ride Height Specs,

August 07, 2010, 02:31:32 pm

2007 Inspire 360 Coach # 52001

I am fairly new to the group, but I have already learned a lot. Thanks to all the members.
I am looking for ride height specs.for my coach. I have searched the files and not found what I need. I know the group does not appreciate rehashing old topics that have previously been posted. I apologize if I am overlooking something. I would also like instructions for performing the procedure.

Thanks,

Dick Barrett

Re: 2007 Inspire 360 Coach # 52001 Ride Height Specs,

Reply #1 – August 07, 2010, 03:55:13 pm

Yahoo Message Number: 62165

Dick, My coach is different but I think the ride height adjustment is about the same, on the IFS located on the torsion bar, center of coach(front axle) there should be a U-clamp holding the ride height valve, you can loosen the clamp slightly and to raise the coach move it forward and to lower the coach move it backwards. I would mark where it is now so as to tell how much you move it., does not take much, you may have to adj. it a couple of times and then measure the difference. The shock, from pin eye to pin eye is probably the best measurement, you may want to drive it a little and re-check. There is just one adjustment on the front... The rear has 2 adjustments, one on each side., just inside the frame behind the tire, it adjust a little different than the front., mine has a 1/4" rod with socket eyes on each end, they are spring loaded, to remove the rod from the socket just push the spring loaded catch up and the rod will come off., just remove one end and Lenghten the rod for height and shorten for Lower...Hope this helps and it yours is a little different you will have to figure out but you will have the basic knowledge... Be careful when working under the coach as not to get swated...in other word have plenty of room to get out... Marvin 07 Allure 31459

Country Coach Owners Forum Country Coach Motorcoach Forum