Skip to main content ↑ ↓
Topic: Re-Installing sheered bolt in slide (Read 529 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Re-Installing sheered bolt in slide

Yahoo Message Number: 76060
CC Owners

I am not Mr. Mechanic, but I would like to know if there is a written set of steps for replacing a sheered slide bolt for the four different slides on our 2005 Inspire.
If anyone know where to purchase the procedure, I would be most appreciative. If after looking at the procedure I may chicken out and not try, but the worst thing would be to screw it up and then call my mobile mechanic.

Stan

Re: Re-Installing sheered bolt in slide

Reply #1 –
Yahoo Message Number: 76068
Stan;

I have attached the procedures that I made for adjusting the front drivers slide plus the official procedures which do not cover everything.
Bob

2005 Inspire 51394

Re: Re-Installing sheered bolt in slide [9 Attachments]

Reply #2 –
Yahoo Message Number: 76075
Bob,

Thank You ,

I really appreciate what you sent. I realize that my frequent bolt sheering is a result of alignment. I think I can try and fix using the procedures you have supplied.

Thank You

Stan - San Diego
Inspire 2005 5140
 

Re: Re-Installing sheered bolt in slide

Reply #3 –
Yahoo Message Number: 76086
Stan,

My coach started shearing bolts at about 3 years of age and it was associated with lots of creaks and squeaks when the front slides were extended. Spraying lubricant on the support tubes, the racks and the gears silenced the squeaks and reduced the frequency of breakage of the shear bolts. I believe the instructions for the slides call for no lubrication but this makes no sense to me.
I have experienced the front and rear of the drivers front slide getting out of alignment by about ΒΌ inch. You should check this carefully because it puts a lot of stress on the slide when it is retracted.
Bob

2005 Inspire 51394