Skip to main content ↑ ↓
Topic: 2004 CC Allure, water pump not turning/staying on, wiring diagram an (Read 569 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

2004 CC Allure, water pump not turning/staying on, wiring diagram an

Yahoo Message Number: 76547
Power to the water pump is not staying at 12v, goes to 3v at some point after turning on manually or otherwise. Have tried replacing pump. We have 3 switches that will not turn on pump. Works intermittantly for periods of time, but then stops. Does anyone know location of the relay that the switches go to or have a wiring diagram for a similar CC model? Thanks much! Tina

Re: 2004 CC Allure, water pump not turning/staying on, wiring diagra

Reply #1 –
Yahoo Message Number: 76551
Before you do anything else, I recommend you find/check/clean the ground connection for the pump.

Jay

05 Inspire

Re: 2004 CC Allure, water pump not turning/staying on, wiring diagra

Reply #2 –
Yahoo Message Number: 76582
If you follow the wiring from the pump you will find an Intelitec controller. You may need to replace the controller with a 15 amp unit to supply adequate power to the newer higher volume pumps.
You also need to verify all the conections (both ends) are clean dry and tight.

Bob Wexler
SOB
 

2004 CC Allure, water pump not turning/staying on, wiring diagra

Reply #3 –
Yahoo Message Number: 76587
Thanks for the advice Jay, we will check it when we are at the RV in a couple of weeks, sounds like a very logical possibility.

Tina