Skip to main content ↑ ↓
Topic: atwood water heater (Read 666 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

atwood water heater

Yahoo Message Number: 79687
We started having some trouble with our Atwood heater. The electric side seems to be heating very slowly or not at all. By the time the water gets to the galley it is just luke warm. The shower is a little warmer, but not much. When I switch to gas the heater fires up but soon goes out. The red light inbetween the gas and electric switches does not go on. I thought it was supposed to be on when we did not have ignition. We have had a good deal of rain up here in WI. Any ideas out there?

Tom Coomes

2005 Inspire 51177

atwood water heater

Reply #2 –
Yahoo Message Number: 80903
We still do not have hot water. Warm enough to take a shower, warm in lavy, cold in galley. We did make a discovery. If the washer is on and running, the water gets hot like it used to. I can hear the propane click on when ever we do use water. I have replaced the t-stats, and diode, and cleaned all the terminals. The hot water is there just not where we need it, unless the washer is going. I give up. Any ideas.

Tom Coomes

2005 Inspire 51177

Re: atwood water heater

Reply #3 –
Yahoo Message Number: 80908
Check the outside shower faucet. If it is on it will mess with your access to hot water.

Bob Wexler
SOB

Re: atwood water heater

Reply #4 –
Yahoo Message Number: 80913
Sounds like a cross feed, the cold and hot water are open to each and the cold water is flowing in with the hot. Is the fixture in the outside bay hooked to a hose with the valves left open?

Mikee
 

Re: atwood water heater

Reply #5 –
Yahoo Message Number: 80933
Thanx. My outside shower was on and that was somehow interfering with the hot water. Water heater back to normal.

Tom Coomes

2005 Inspire 51177