Skip to main content ↑ ↓
Topic: Problems with EMS(intellitic) or Inverter(xantrex 3000psw)?? (Read 850 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Problems with EMS(intellitic) or Inverter(xantrex 3000psw)??

Yahoo Message Number: 87080
After using 30amp service, the Inverter does not Invert, shows code 207, Low Batteries, but the batteries show 13.6 volts. At the park now we have 50 amps and the EMS did not light up, and some appliance did not work. Not sure if it is the EMS shedding loads or the Inverter not working properly? I did disconnect shore power, reset battery to Inverter, Cleared code, and the charger works fine, The EMS shows the 50amps service, but as I drop the shore power the inverter does not function properly, goes back to the 207 code. This all happened after using 30amp service, I have the Xanterx 3000 Pure sine wave, and the remote panel. All advice welcome.
2007 Allure 470 #31459
 

Re: Problems with EMS(intellitic) or Inverter(xantrex 3000psw)??

Reply #1 –
Yahoo Message Number: 87087
I had read about this error code before. The following is what I found

Error Code 207 - Internal DC Bus voltage low.
Temprary condition caused by low battery voltage in conjunction with an overload condition.
  • Internal fault.
  • Check if battery is OK (see error code 002).
  • Disconnect AC and DC power to the Reconnect DC and AC power after 15 minutes
Me be worth a try
Dick

Inspire 51976

[/color][/font][/size]