Skip to main content ↑ ↓
Topic: ABS Light (Read 606 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

ABS Light

Yahoo Message Number: 108821
Had the rear axle seal changed and when completed I had an ABS light staying on. It was thought the wire was pinched when they did the seal job, so a new sensor cable was ordered from Country Coach Winnebago. It took all day to take apart the whole seal and drop disk brake assembly and remove back plate to install the new sensor. Major job.
Problem still exists showing on silverleaf " 4 8 1 sensor axle2-R slip". They have tried resetting with no luck.
Not sure what code was showing before because they tolld me it was showing a code, so I didn't pay attention.
Any ideas?

Buddy Bordes 08 Allure Sunset 37 #31597
 

Re: ABS Light

Reply #2 –
Yahoo Message Number: 108823
Sounds like the pick up is too far from the one ring, this is typical after an axle seal replacement. Get the sensor distance adjusted.

Mikee