Generator "Petsafe" Auto Start Question
Yahoo Message Number: 114170
Group:
Our Silverleaf has an option in the Generator Menu for "Thermostat" which I assume is a Hi-Temp Thermostat that when closed, energizes the Generator (Cummins 10Kw) Auto-Start so that in the event of a power failure the A/C would continue to run for "Pet-Safe" reasons. I've set the condition on the Silverleaf to "Enabled" , shut down Shore Power and Set the A/C to a low temp - thinking that the A/C Zone Control Boards are what control the Genset Autostart. My thinking was to set the thermostats really low (Like 60 deg) and that should "force" the Genset to autostart. An hour later, its plenty warm in the coach (We are FL in the 80's) and no Genset Autostart.
From a troubleshooting perspective, if the "Petsafe" feature is controlled by the Zone Control Boards in the A/C units (Coleman Mach 3 15K BTU), then any ONE of the THREE units would signal a Genset Start. So far, no go. Does anyone know if there is a separate temp circuit that controls the Petsafe and where that would be located?
Am I missing something? One of my thoughts was that its not the Room Thermostats but a separate thermostat on the zone control board that is "hard wired" to a specific temp (Like 80 deg.) that sets the Genset to Autostart.
As usual, when I'm stumped, I throw it out to the group. If I find the solution myself, I'll post it for everyone.
Jim
Jim and Jona Seifert
2007 Country Coach Intrigue Ovation 530 42'
Coach #12150
525 Cat C13 Allison 6spd
Toads: 2014 Ford F150 / 2007 Toyota FJ Cruiser w/ REMCO DS Disconnect.
Airforce 1 Brake system
Blue Ox Aventa II Towbar