Skip to main content ↑ ↓
Topic: Over active entry step (Read 698 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Over active entry step

Yahoo Message Number: 12810
Terry was sitting on the entry step while I switched on the ignition. The entry step dumped her on the ground.
I should have remembered that step was way too active & would retract when key turned.

As installed, the step moves at least 10 times for each time it should move.
How can I modify it to retract only when door is closed while engine is turning?

Eric & Terry Elliott
5 Inspire 51321
 

Re: Over active entry step

Reply #1 –
Yahoo Message Number: 12811
That's the way it was in the 90's and you should have heard all the griping and complaining about people knocking off their steps or bending the rails.
I had to replace my rear rail twice, because the door closure switch was intermittent and the steps didn't pull in and the panel light was out. I hit a plastic 50 gal orange & red warning barrel and the second time an electrical stanchion in an RV park. I got so I could drop the steps and replace or straighten the rails in an hour and a half. Don't know what bent the rails the 3&4th time; but, I was able to save the rails. TWI 98 Allure 30255, 2004 Intrigue 11731