Skip to main content ↑ ↓
Topic: Squeeky steps revisited (Read 659 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Squeeky steps revisited

Yahoo Message Number: 19754
Larry, et al

Having previously replaced the damaged rubber headed bolts in the same holes that Kwikee used, and learning from this forum I probably did it wrong just like Kwikee did,I obtained two more and placed them in the holes above the ones previously used. This resulted in the rubber contacting a flat vertical plate instead of the sharp edge of a horizontal piece. This works. The ones I had put in just a few weeks ago were already severly damaged by being cut into by the edge of steel they contacted. Squeek is gone and I am confident it will remain gone.

Thanks to the forum and, if I remember right, Larry Feather for his good advice.

Lyle Wetherholt
04 Intrigue 11740
 

Re: Squeeky steps revisited

Reply #1 –
Yahoo Message Number: 19759
Glad to here it Lyle. I used the "other" hole too and it's working great! No squeeks and solid steps. Think we should tell Kwikee? I wonder how many years they have been doing it wrong? Happy holidays.

Larry, 2003 Allure #30856

Quote from: Lyle Wetherholt