Skip to main content ↑ ↓
Topic: ABS light (Read 668 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

ABS light

Yahoo Message Number: 90465
I had to replace the right front brakes(wheel oil seal leak). Works all done. Now ABS light stays on. Any thoughts out there.

Don

98 Intrigue
10678

Re: ABS light

Reply #1 –
Yahoo Message Number: 90470
The sensor probably needs to be adjusted after the wheel was removed. But first be sure the wheel hub, etc, is installed correctly. If you had a shop do it they should check and adjust it for free.

Mikee

ABS light

Reply #2 –
Yahoo Message Number: 91383
My ABS light is ON. This has happened before and I was able to extinguish it by turning the ignition switch OFF and then back ON. Not so this time. Can anyone suggest some trouble shooting or remedial steps I can take?

Jim Biestek

'04 Intrigue 11783

P.S. I sure wish I could figure out how to research previous posts on Yahoo. I just tried again, because I'm sure this subject has been covered in the past. No luck.

Re: ABS light

Reply #3 –
Yahoo Message Number: 91386
My comes on if I drive any distance, normally very slow maneuvers around a camp site, with the tag up. There is supposed to be a speed limit for this issue and i am sure I am no where near that. It clears itself after a short drive with the tag down.

Michael 2008 Allure 31683

Re: ABS light

Reply #4 –
Yahoo Message Number: 91449
Not sure if you solved the issue yet , I had the similar problem after a shock failure . Used the silver leave to read fault code , fault code indicated the issues was on the same wheel as my shock failure . A quick look reveled the magnetic sensor wire had been crunched . I fixed the wire and the fault went away.
04 Intrigue 11840
 

ABS light

Reply #5 –
Yahoo Message Number: 95823
Does anyone know what makes the ABS light activate? Ours comes on once and a while when it is raining out or even sometimes when the weather is just real humid out.

BVL

2003 Allure 36 First Ave