Skip to main content ↑ ↓
Topic: 2000 Allure Locker Door Hinges? (Read 1579 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

2000 Allure Locker Door Hinges?

Yahoo Message Number: 109455
Hi,

I have a 2000 Allure. The doors on two of my outside locker doors have started to come apart at the hinge at times; that is the door hinge section comes unhooked from the coach body hinge section. I can reconnect the hinge sections and continue using them, but it is frustrating. Is there anything I can do to remedy this problem?

Thx,

Brian Hoxie
CC# 30507

Re: 2000 Allure Locker Door Hinges?

Reply #1 –
Yahoo Message Number: 109456
Brian,

These are known as "Continuous Hinges". The door half of the hinge is designed to release from the body half only when the door is lifted high. Normally the gas deck props limit the travel to prevent the two halves from parting. Have the deck props been replaced with non-stock extra long units that extend too far? ...Or, have the hinge extrusions been deformed? Either of these conditions may cause release.
Daron Hairabedian 98 Allure 30226

Re: 2000 Allure Locker Door Hinges?

Reply #2 –
Yahoo Message Number: 109457
There are great epoxy's that will attach solid to frame.

Received David

Re: 2000 Allure Locker Door Hinges?

Reply #3 –
Yahoo Message Number: 109458
I had an "ouch" experience with one of my storage doors and reinstalled it with hollow wall anchor bolts from Lowes/ Home Depot.

.40 - 3/16 inch x 3 inch Hollow Wall Anchor Toggle Bolts (50) [TB3163] :...

Been good for two years now and don't see why it won't last.

Jerry & Brenda Azzara
'99 Intrigue Chefs Delite
#11702

Re: 2000 Allure Locker Door Hinges?

Reply #4 –
Yahoo Message Number: 109471
Daron,

The props have been replaced, but I was very conscious about matching the new ones to the previous ones, both length and strength. I don't know of a time the doors were opened too far, but it may have happened. What do you think about laying a 2"x 4" on the hinge while closed and hitting the board once or twice with a hammer? This should snug up the hinge a bit. I'm also considering just using shorter props so the doors don't open as far.

Thoughts?

Brian
CC# 30507
 

Re: 2000 Allure Locker Door Hinges?

Reply #5 –
Yahoo Message Number: 109474
Brian,

You might try that but I think it may be very difficult to control the force. If you squeeze it too far it will squawk upon operation. That extrusion is medium tempered (T-5) that gets more brittle with age. Pretty tricky! I do not know if it is still available but, have you thought about replacing the offending hinge? That type of hinge was also used on lift doors for pick-up truck covers and removable RV tables for many years.
Daron