Skip to main content ↑ ↓
Topic: Step Cover Failure (Read 814 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Step Cover Failure

Yahoo Message Number: 18397
Well, I think we did something wrong. On a trip last week my copilot stored her shoes on the first step just under the cover. When we arrived at our destination we tried to retract the cover and after retracting about half way it stopped moving. We could see it had caught on the shoes. We removed the shoes but now the cover will not move when the switch is activated. We can hear the motor running so we did not blow a fuse or trip a breaker.
We are looking for advice on where to start on fixing this failure. Our coach is a 98 Intrigue.
Thanks in advance for any guidance.

Mike and Marg Keogh
98 Intrigue 36 #10538
00 CRV

Re: Step Cover Failure

Reply #1 –
Yahoo Message Number: 18400
Grab the step and give it a nice hard pull to see if that frees it up. We have a 99 Intrigue that has been plagued with stairwell cover problems.

--- Mikeogh@... wrote:

Quote
Well, I think we did something wrong. On a trip > last week my copilot stored

her shoes on the first step just under the cover.
When we arrived at our

destination we tried to retract the cover and after > retracting about half way

it stopped moving. We could see it had caught on > the shoes. We removed the

shoes but now the cover will not move when the > switch is activated. We can

hear the motor running so we did not blow a fuse or > trip a breaker.

We are looking for advice on where to start on > fixing this failure. Our
coach is a 98 Intrigue.

Thanks in advance for any guidance.

Mike and Marg Keogh
98 Intrigue 36 #10538
00 CRV
Gene Clendenin

My mind works like lightning. One brilliant flash and it is gone.

Re: Step Cover Failure

Reply #2 –
Yahoo Message Number: 18401
There is a pinion gear, held on with a set screw. It is located in the first compartment drivers side. It is possible that the set screw that holds this gear to the gear motor shaft has come loose. You should be able to get to it from the compartment. Good Luck.

Everett

99 Intrigue 10758

Re: Step Cover Failure

Reply #3 –
Yahoo Message Number: 18406
Mike: I've had my cover motor out at least three times in seven years. (Finally decided to abandon the &%$ thing). You can access the entire assembly if you are inclined to venture into some mechanical territory.
Underneath the coach, up front under the steps is a flat sheet metal piece that covers the mechanism. It's pretty easily removed with a long bit extension and a power screwdriver or drill. By removing the cover and taking the primary bolt out, you can free up the cover and if you are ambitious, you can remove the entire assembly for repair.
The wires are coded, both with color and numbering system, so it is easy to reinstall. Everything is pretty easy to each, especially if you drive the front end up on some blocks so you can sit up underneath the front end.
Hopefully you can fix the motor without having to take the assembly out.

Good luck.

Larry
Intrigue
10762

Re: Step Cover Failure

Reply #4 –
Yahoo Message Number: 18411
My description was not accurate. I can make the cover move manually but I can hear the motor run when I activate the switch. It seems as though the cover is disconnected from the motor. I will try the pinion gear in the morning. Thanks for the advice.

Mike and Marg Keogh
98 Intrigue 36 #10538
00 CRV
 

Re: Step Cover Failure

Reply #5 –
Yahoo Message Number: 18412
It could be that the rod-end bolt that attaches to the door, became disconnected. I just replaced the microswiches in my step cover and during disassembly, I noticed that the rod-end attach bolt was loose. This is accessed through the previously-mentioned panel underneath the front of the coach. Good luck.

Larry, Debbie, Tiki and Tomi (Pugs) USAF Retired

2003 Allure #30856

Quote from: Everett Smith
> There is a pinion gear, held on with a set screw. It is located

in the

Quote
first compartment drivers side. It is possible that the set screw

that

Quote
holds this gear to the gear motor shaft has come loose. You
should be able

Quote
to get to it from the compartment. Good Luck.

Everett

99 Intrigue 10758