Skip to main content ↑ ↓
Topic: Any one have similar problems to advise (Read 1322 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Any one have similar problems to advise

Yahoo Message Number: 4292
Two reoccuring problems seem to give me fits: My inverter, mfg. Hart interface seems to need to be jolted into operation due to a loose circuit board. I removed it and sent it to the mfg. under warranty.
They could find no problems. (surprise, surprise!) Now it works intermittently. When it chooses not to work, I tap it with a screwdriver or whatever is available and it works for a while, only to reoccur. Looks like I need to buy a new one. Anyone have similar problems with this item?

My step slide cover only works when it wants to, despite many, many efforts to fix it, including replacing the motor and switch. I have given up and decided to try to adapt an air-actuated cover. Has anyone had similar problems?

Re: Any one have similar problems to advise

Reply #1 –
Yahoo Message Number: 4296
Larry,

Fred is probably correct (he usually is) but from my own experience you could have a low voltage problem.

I don't know which coach you have or if CC made any changes since I had the problem. It appeared that the point at which the power was tapped for the step motor couldn't provide enough voltage to properly power the motor.

Just another possiblity.

Dick May

2002 Intrigue, #11438
Dick May
2002 Intrigue, #11438, towing a
2014 Jeep Gr Cherokee ecoDiesel

Re: Any one have similar problems to advise

Reply #2 –
Yahoo Message Number: 4303
How was the situation rectified to provide regular or proper voltage at that point? Mike Allure 2000

On Wed, 26 Feb 2003 20:30:48 -0000 "dickmay_2000 maymr@...>" maymr@...> writes:

Re: Any one have similar problems to advise

Reply #3 –
Yahoo Message Number: 4307
Quote from: rvmike@j\.\.\.
How was the situation rectified to provide regular or proper voltage
The main reason for low voltage (under load) is connectors that aren't tight enough and/or are dirty, corroded.
Not just the +12V but also the ground connectors, as any significant resistance from the supply or return path will make the voltage decrease (when under load).

Usually just 4 points need to be examined (for a single circuit problem): - connection to the fuse.

- connection to the consuming item.
- ground wire and its 2 connections.
The higher the power consumption (wattage, amperage) of the consumer is, the more sensitive it is to poor connections, and likely the place where the consumer is makes it more likely to develop some poor connections (the doorsteps come to mind).

Henk Bots, Magna 2000.