Skip to main content ↑ ↓
Topic: door wiring (Read 413 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

door wiring

Yahoo Message Number: 61515
After having trouble with key fob I checked the wires in the door and found that 12 wirew are in harness two are not used. #4 wire is the wire for the step light. If I touch the wire to door after removing it from the junction box ( when removed light goes out) if I touch the end to the door panal it goes on. I can also touch the same end to #8 and the alarm with yelp. I assume the problem is as most of you have descriped, the wires between door and coach are bent or damaged from door opening and closing. I have checked each wire with ohm meter and they seem to be good. But, based on the alarm problems you have reported I think that I will replace all 12 wires from the right front headlight area to the door. Not sure what I,am going to wrap them in yet. Any suggestions from anyone that has done or had this done.
Anyone cleaned the spark arrestor on a 10,000 onan that is on an 07 allure? Says take top panal off. It appears that if you take it off you cannot get to the nut because the top is still under the windshield of the coach. After this the "wet Kit" then if any hair left maybe use the coach again.
Thanks in advance for any help or suggestions.
Don 07 Allure 470 #31588