Skip to main content ↑ ↓
Topic: Supplementary to Slide Toppers on 2008 Allure Sunset Bay Quad Slide (Read 439 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Supplementary to Slide Toppers on 2008 Allure Sunset Bay Quad Slide

Yahoo Message Number: 82753
After my last post I tried to bring the slide in and the cloth would not roll back correctly so about 12 inches from full in I reversed the slide back out and gallons of water poured out of the topper pocket/casing. The cloth then went taut and retraction operated correctly. The truss assembly still looks slightly lower than the rear two.
So the questions are fundamentally the same as the last post and I would appreciate any input on the tensioning of the truss and cloth. But additionally why has water accumulated in the case? Also forgot serial number now added.

Michael

2008 Allure Sunset Bay Quad slide 31683

Re: Supplementary to Slide Toppers on 2008 Allure Sunset Bay Quad Sl

Reply #1 –
Yahoo Message Number: 82781
Mike

Get up on the roof after a good rain and you will see the problem, the tent structure traps water and it stays there until you bring in the slide. You need to bring the slide in very slowly. I have seen the factory attempt to adjust and replace the structure with out any permanent resolution. By the time they got to me they were just removing the whole thing.

Dan 2006 Allure 31348