Skip to main content ↑ ↓
Topic: Norcold Control Board Burned Trace (Read 566 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Norcold Control Board Burned Trace

Yahoo Message Number: 90165
Had the frig go out the other day. I rigged up a temporary power source, found the problem and fixed it. Back on line now and didn't have to throw out any food. Perhaps this little adventure might help a few others out there. THIS WAS NOT A COOLING UNIT RELATED PROBLEM OR MELT DOWN.

Read my chronicle here if there's interest: http://www.muniac.com/ubbthreads/ubbthreads.php?ubb=showflat&Number=216#Post216 --

Best - Scott

2006 Allure 430 40' #31349

(Bus-Stead Lemon) My Allure Page http://www.muniac.com/Allure%20Page.html

Re: Norcold Control Board Burned Trace

Reply #1 –
Yahoo Message Number: 90167
Great post, Scott! I hope I never need to use it. I liked the advice about Dinasaur's low cost boards.
Daron Hairabedian, 98 Allure 30226

Re: Norcold Control Board Burned Trace

Reply #2 –
Yahoo Message Number: 90170
Daron - I was hoping someone out there has used one of the after market boards and can comment. They look reasonable well made but an actual review would be best. Safe travels to all.

Best - Scott

2006 Allure 430 40' #31349

(Bus-Stead Lemon) My Allure Page http://www.muniac.com/Allure%20Page.html

Re: Norcold Control Board Burned Trace

Reply #3 –
Yahoo Message Number: 90186
The Dinosaur boards work very well. It is all I use for repairs.

Mikee