Skip to main content ↑ ↓
Topic: Water pump control module (Read 865 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Water pump control module

Yahoo Message Number: 93003
As a follow up to a previous post we (Kevin Waite) and I suspected that my water pump being on standby all the time and the three switches not turning it off, was an issue with an Intellitec 10 amp latching controller. Physical inspection showed that we do not have such a controller. However, behind the monitor panel there is an open printed circuit board that seems responsible for that function. Schematics that came with the coach do not show how the three switches are wired and what controls the switching function. Kevin says the board was manufactured by CC but before I contact them I am looking for any intelligence available of the subject. I would not be surprised that the pc board is not available so I am seeking input on solutions if not.
Lyle Wetherholt
04 Intrigue 11740

Re: Water pump control module

Reply #1 –
Yahoo Message Number: 93005
On my 2002 Intrique I just by passed that board and took 12 volt from my power cord to energize the water pump. Pump runs when I turn on the water. Pump will also run when filling fresh water tank. To stop that I just pull the ground. Been working this way for two months with no problem. Mike # 11422

Re: Water pump control module

Reply #2 –
Yahoo Message Number: 93021
Lyle,

Not sure if this will be useful in your particular case, but here goes.
When I was having some solar panel work done at AM Solar in Eugene (now in Springfield), OR one of the engineers mentioned that AM Solar had done custom circuit board design and fabrication for Country Coach over the years. The water pump board sounds like something they (or he personally) MIGHT have had a hand in.
The individual I was working with (circa 2006) was Dale Seese, who may or may not still be with AM Solar (541--738-1091).
--

Tom Harsch 2002 Allure #30791
Laughlin, NV

Re: Water pump control module

Reply #3 –
Yahoo Message Number: 93024
Tom, et. al,

Thanks for the response. I intend to explore all avenues including CC. If nothing works then it will be back to the drawing board for a self designed solution.
Lyle Wetherholt
04 Intrigue 11740

Re: Water pump control module

Reply #4 –
Yahoo Message Number: 93026
Tom, et. al.

This is my second attempt to say thanks for the responses. This new yahoo system didn't send my first reply. I will investigate all input from the group and I thank you for giving me avenues to follow.
Lyle Wetherholt
04 Intrigue 11740