Skip to main content ↑ ↓
Topic: Toilet not working (Read 595 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Toilet not working

Yahoo Message Number: 96088
The toilet in my 2003 Affinity has lost its WHOOSH. When I press the button to flush it, water just trickles - the strong draining and brief rush of water is no longer there. It is a Headhunter toilet. Anyone have any solutions?

Re: Toilet not working

Reply #1 –
Yahoo Message Number: 96089
Head hunter toilets trigger the headhunter water to pump when they are flushed. You might want to check the pump is actually coming on when the toilet is flushed. The Headhunter pump is a 3 stage pump if one or 2 of the stages have failed you will get the same issue. What pressure does the headhunter pump cut in and off at?

Mikee

Re: Toilet not working

Reply #2 –
Yahoo Message Number: 96091
Headhunter advised me the bladder in my pressure tank had hole which would lower pressure required to flush proper. I will be checking this next week same problem as you have.

Re: Toilet not working

Reply #3 –
Yahoo Message Number: 96166
there is also a micro switch located in behind the toilet that controls the flush cycle. I was experiencing the same symptoms as you are. Locate the switch (it should be valcro'd inside the back of the toilet). You will be able to fish it out. Then disconnect the switch and short the two leads bypassing the switch. A simple test. At worst it will eliminate one possibility but these switches to go bad and are easy to replace.

Kevin D