Skip to main content ↑ ↓
Topic: 2 wires for DanFoss Fan Controller (Read 862 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

2 wires for DanFoss Fan Controller

Yahoo Message Number: 102086

I am trying to clean the wires to my fan controller. I have found and cleaned the 3 wire connector but the 2 wire goes into the DanFoss control box and I am not sure if I should take this apart to try and clean them or not. I have provided 3 pictures (attached) of the wires going into the control box. Can I remove the four screws to access the 2 wire connection in the control box? I am sure this is a printed circurt board and as such there is certain proto calls that are supposed to be used when dealing with them, correct? Anyway, before I proceed any further I thought I would ask if I should continue opening the DanFoss control box to clean the 2 wire connection in there?

Thanks,

Ken Mikkelson

2005 Inspire 51494

Re: Fw: 2 wires for DanFoss Fan Controller [3 Attachments]

Reply #1 –
Yahoo Message Number: 102087
Ken,

I have the same Danfoss controller that you have. I just recently removed the controller and cleaned all the wire contacts. There is no problem in removing the controller as it is a sealed unit.
Unfortunately mine still gave inconsistent fan inputs so I have a new controller on order RJ

2005 Inspire #51264

Re: Fw: 2 wires for DanFoss Fan Controller

Reply #2 –
Yahoo Message Number: 102088
Ken

No reason to take the four screws out of the Electronic Control box as those wires going into the box terminate into a "sealed potted material" therefore the wires cannot be cleaned or tightened.

Mike 03 Allure 1st Ave. #30898 ISL 370

Re: Fw: 2 wires for DanFoss Fan Controller

Reply #3 –
Yahoo Message Number: 102089
Thanks RJ I will take it off and hopefully it will take care of my problem.

Ken

Re: Fw: 2 wires for DanFoss Fan Controller

Reply #4 –
Yahoo Message Number: 102090
Mike,

Are we talking the same engine as I see you have a Cummings and I have a cat? Are the fan control units the same? Just curious. As I have received conflicting advice

Ken Mikkelson

2005 inspire 51494

Re: Fw: 2 wires for DanFoss Fan Controller

Reply #5 –
Yahoo Message Number: 102104
Ken, I believe the Fan Control Units are physically the same, the difference with the CAT engine is probably the electronic protocol which can be determined by the part number. Mine is #1090409, yours may be probably different.

Thanks, Mike 03 Allure 1st Ave.#30898 ISL 370