Skip to main content ↑ ↓
Topic: Brake Lights won't go out (Read 1228 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Brake Lights won't go out

Yahoo Message Number: 105532
I have a 2007 CC 37 ft Allure 470. Does anyone know where the brake light solenoid is located. I need to replace mine because it is stuck and the brake lights will not go off. No matter how many times or hard I pump the brakes, it will not unstick and allow the brake lights to go out. I thought it was in the street sidefront bay where the 12 volt fuses are located. But I cannot figure out which electrical/air solenoid it is. We are traveling right now, and it is a little unnerving knowing that the brake lights are on while you are driving down the interstate. Thank You

Re: Brake Lights won't go out

Reply #1 –
Yahoo Message Number: 105534
Don't know where the switch is, but when we had the same problem, reaching down and pulling up on brake pedal by hand would turn if off. Took a new switch to fix it..

Mike & Anne Spinetti

Outdoor Resorts Indio # 259
Las Vegas, Nv.
Jackson, Calif.

2008 CC Allure #31619 Cell 702-592-1250 email:: m82249s@...
__==____==___

[ CC [__][ ] [] [_] \ =- (O)(O)-- [ ] -- (O) =

I have a 2007 CC 37 ft Allure 470. Does anyone know where the brake light solenoid is located. I need to replace mine because it is stuck and the brake lights will not go off. No matter how many times or hard I pump the brakes, it will not unstick and allow the brake lights to go out. I thought it was in the street sidefront bay where the 12 volt fuses are located. But I cannot figure out which electrical/air solenoid it is. We are traveling right now, and it is a little unnerving knowing that the brake lights are on while you are driving down the in terstate. Thank You

Re: Brake Lights won't go out

Reply #2 –
Yahoo Message Number: 105539
On my Monaco in the frb is a F8 board with relay that brakes and compression brakes are controlled. Just unplug board to reset. Should fix your issue TomG

2007 MonacoDynasty Diamomd IV

Re: Brake Lights won't go out

Reply #3 –
Yahoo Message Number: 105540
If you have a floor mat, make sure that it is not under the heel of the brake pedal. This almost to simple, but I had to do away with floor mats for the drivers feet. On some of these pedals, it won't take a 1/4 inch to make the brake lights come on

Re: Brake Lights won't go out

Reply #4 –
Yahoo Message Number: 105545
I too had problem with floor mat causing brake light to remain on. I had a thin floor mat that would slide beneath brake pedal causing cruise control to deactivate and the brake lights stay on.

Re: Brake Lights won't go out

Reply #5 –
Yahoo Message Number: 105553
Thanks for the suggestion. But I only have a tile floor underneath my pedals. The carpet floor mats that came with the coach slide around too much for my liking. I was able to get the brake lights to go off by hitting the linkage under the brake pedal, but I don't know what behind the brake pedal made them go off.
Thanks again for your help.