Skip to main content ↑ ↓
Topic: Hydraulic Oil Light on the dash (Read 1262 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Hydraulic Oil Light on the dash

I have a 2010 CC 36' Inspire. Only since the Caterpillar Dealer worked on the regen system on my C9 Diesel (replaced the ARD head) has the Red Hydraulic Oil light been on the dash. They claimed it was on when I brought it in which it was not. All systems seem to be working normally. I changed the filter for the system but mine does not have a sensor in the filter housing as shown in the manual. I cannot find a sensor anywhere or a reset button in the right rear compartment as another person reported. Any ideas would be greatly appreciated. Thanks

Re: Hydraulic Oil Light on the dash

Reply #1 –
2010 - Interesting.  May have been finished outside of CC factory?  My sensor is on round hydraulic tank - at the back!  Cant really see it unless I put a phone back there and take a picture.  I can also see it from the inside if I remove the clamp and take the lid fully off.
2007 Country Coach Allure 37 Sunset Bay 400ISL

Re: Hydraulic Oil Light on the dash

Reply #2 –
Pull the dash and check the wires, if CC did it there will be #'s. Then check your Binder elect drawings.
2004 Magna 42' 3 slide Chalet CC#6315M
C-15, 515HP 1650tq.

Re: Hydraulic Oil Light on the dash

Reply #3 –
FWIW on my 2009 Allure 470 500ISM, we have a reset switch that need to be activated if the light comes on and you service the system.  The light is a service reminder for the filters and oil.  You will still operate without issue as it's only a reminder.  Once you depress the switch the light will reset for the next (Time or mileage) period.  As stated above your switch maybe hidden.  My switch is yellow and well labeled next to the chassis battery shut off switch.  Good luck.
Tony & Sheri
2009 Country Coach Allure 470 Crain Prairie
#31688
2012 GMC Arcadia - Toad