Skip to main content ↑ ↓
Topic: Keyless Entry (Read 1311 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Keyless Entry

Does anyone have more specific instructions on how to reset the keyless entry? I am the third owner and don't have the preset code.
Thanks
2007 CC Magna 630 Galileo #6762.

Re: Keyless Entry

Reply #1 –
My 2007 Allure has a Trimark security/door system however without the discrete key pad.

If Trimark system the "authority code" is sometimes set at 4444.  Other wise you can ground out the system and reset a new authority code.  Link here  http://www.trimarkcorp.com/en/media/eask/SB111%20Discrete%20Keypad%20Code%20Setting%20(9-Wire)_Rev2.pdf

Hope this helps,
Brian
2007 Country Coach Allure 37 Sunset Bay 400ISL

Re: Keyless Entry

Reply #2 –
Thanks,
I will give a try and let you know

Re: Keyless Entry

Reply #3 –
Here are the steps you can take to reset the keyless entry system on your vehicle:

    1. Locate the "learn" or "program" button on the body control module (BCM). This is usually found under the dashboard on the driver's side, but it can also be located in the trunk or under the hood.

    2. Disconnect the negative battery cable from the battery.

    3. Wait for at least one minute.

    4. Reconnect the negative battery cable to the battery.

    5. Within five seconds of reconnecting the battery, press and hold the "learn" or "program" button on the BCM until the door locks cycle (about 15 seconds).

    6. Release the "learn" or "program" button and follow the instructions in your owner's manual to add new keyless entry codes.

If the listed instructions don't work, it might be a good idea to contact a reputable and trusted local locksmith in SE20. They should be able to assist you with resetting the keyless entry and provide any additional guidance or recommendations. It's always best to work with a professional locksmith rather than attempting to fix the issue yourself, as improper handling can cause further damage to the system.