Skip to main content ↑ ↓
Topic: Problem with a slide (Read 737 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Problem with a slide

Yahoo Message Number: 9532
Has anyone had a problem with a slide out not closing flush? I have a 2004 Inspire in which the bedroom slide out sticks out abour 1/4 to 3/8 of an inch on the top left, bottom left and bottom right corners and is indented about the same distance on the top right corner. After several hours of trying to adjust it, Beaudry RV in Mesa and the local Country Coach technical rep say it is within spec and they can't do anything more about it. Anyone else have a similar experience...and if so, how did it turn out for you? Thanks for any and all comments.

Tony Ferrara
Phx. AZ

Re: Problem with a slide

Reply #1 –
Yahoo Message Number: 9539
Tony:

I had a similar problem last year. The slides would creep out a couple of inches.
CC replaced a couple of solenoids; however, I am uncertain if the Inspire slide mechanism is the same as the Intrigue.

Chuck Penque

03 Intrigue 11673

Re: Problem with a slide

Reply #2 –
Yahoo Message Number: 9549
Its not, Inspire is gear driven and an Intrigue is Hydrualic with pistons, unless you have the serpantine units. TWI Intrigue 11731

Re: Problem with a slide

Reply #3 –
Yahoo Message Number: 9550
The serpantine also has hydraulic pistons, 4 of them. I had to bleed them after replacing the synchronizing cylinder, what a nightmare! I think electric/gear may be better...
Tom

02 Allure 30780