Skip to main content ↑ ↓
Topic: Dometic AC Problem (Read 704 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Dometic AC Problem

Yahoo Message Number: 18937
The fans will not work on either the front or rear AC units. The compressors are working as I can hear them come on but I don't want to leave them very long with no fans running. The hydroHot circulator fans are working on Furnace.

I had this problem a year ago at Lazydays but the fans came on within a few hours of leaving the controller set to fan only. This time that doesn't seem like its going to happen. By the time Lazydays got to it there was nothing broken.

Anyone had this experiene before?

Thanks

Don & Mary Seager
2004 Allure 31046

Re: Dometic AC Problem

Reply #1 –
Yahoo Message Number: 19051
I talked to the Dometic techs at FMCA about a similar problem and they suggested it was probably caused by interference from a bad ballast in one of the florescent lights. Assuming you have a five button thermostat, you can clear the memory by turning the slide switch to off, pressing and holding the MODE (top) and the ZONE (bottom) buttons while moving the slide switch to the on position. If FF appears in the readout, the unit has been reset. Turn on your lights one at a time and when it starts acting up, you have found the faulty light--it is most likely one that is close to the thermostat.

Don & Janet Scott
02 Allure # 30799
VW R32 etc