Skip to main content ↑ ↓
Topic: Slideout rubber seals (Read 588 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Slideout rubber seals

Yahoo Message Number: 26427
One of the vertical rubber seals on my front slideout is coming loose at the bottom.
About a foot of the seal goes in and out as the slide is retracted and extended. Does anyone have any experience with this problem?

George Board
`03 Allure 30871

Re: Slideout rubber seals

Reply #1 –
Yahoo Message Number: 26430
Yes, I had that problem and I reattached it with silicone sealant.
Not sure if that's the right stuff, but it has held for more than a year.

Larry 03 Allure #30856

Quote from: gwboard2000
One of the vertical rubber seals on my front slideout is coming
loose at the bottom.

Quote
About a foot of the seal goes in and out as the slide is retracted
and extended. Does

Re: Slideout rubber seals

Reply #2 –
Yahoo Message Number: 26433
Quote from: gwboard2000

> One of the vertical rubber seals on my front slideout is coming loose
at the bottom.

Quote
About a foot of the seal goes in and out as the slide is retracted
and extended. Does

Quote
anyone have any experience with this problem? >

George Board
`03 Allure 30871
I had this problem on my 2001 Intrigue. CC calls this a sweep seal.
Mine was replaced at a rally--part was about $50, but there was considerable labor involved. They used a large jack to hold the slide room up, then removed the old seal and installed the new one.
Dale Loop

Intrigue 11240